View TPAC175P-490O_1327960.PDF datasheet online --- IC-ON-LINE

Datasheet File OCR Text:

UNIVERSAL AC INPUT HARMONIC CORRECTION AC-DC HOT-SWAP CompactPCI QUAD OUTPUT 175 WATTS CURRENT SHARING SWITCHING POWER SUPPLIES TPAC175P & TPAC175D SERIES
FEATURES:
175W IN 3U X 8HP EUROCARD PACKAGE UNIVERSAL AC INPUT WITH PFC INTERNAL OR-ING DIODES FOR N+1 REDUNDANCY HOT-SWAPPABLE DROOP CURRENT SHARING EMI MEET EN55022 / FCC CLASS A CE MARKING COMPLIANCE FULLY COMPLIANT WITH PICMG
TOTAL POWER INT'L
SPECIFICATION
INPUT SPECIFICATION
Input Voltage: Typ. 90-264Vac with PFC. Power Factor Correction: Meet Harmonic Correction IEC1000-3-2. Power Factor typ. 0.98. Input Connector: PCIH47M400A1 for TPAC175P. DIN41612 M24/8 for TPAC175D. Input Frequency: 47-63Hz. Inrush Current: Less than 30A @ 230Vac.By thermistor. Input Current: 2.2A @115Vac/1.1A @230Vac for TPAC175D. 2.4A @115Vac/1.2A @230Vac for TPAC175P. Dielectric Withstand: Meet IEC950 regulation. EMI: Meet EN55022 / FCC Class A. Hold-up Time: 5mS @115V & 230Vac after power fail signal. Remote ON/OFF: Available at [INH#] & [EN#] pins. Power Fail Signal: Available at [FAL#] pin. Status LED: means valid input voltage. means a critical fault. Thermal Protection: Installed NTC for thermal sensor at [DEG#] pin. Earth Leakage: Less than 0.5mA @230Vac.
OUTPUT SPECIFICATION
Output Voltage: See Ratings Chart. Output Current: See Ratings Chart. Output Wattage: Typ. 175W continuous. Output Connector: PCIH47M400A1 for TPAC175P. DIN41612 M24/8 for TPAC175D. Line Regulation: Typ. 0.5%. Load Regulation: VO1 & VO2 typ. 1.0%. VO3 & VO4 typ. 2.0%. Noise & Ripple: Typ. 1% peak-peak or 50mV, which is greater. OVP: Built-in at VO1 & VO2. Adjustability: Available at VO1 & VO2. VO3 factory set. Remote Sensing: Available at VO1 & VO2. Hot-Swap: Available. N+1 Redundancy: Installed with OR-ing diodes for N+1 redundancy operation. Current Sharing: Droop current sharing at all output. Power OK Signal: Available for VO1 & VO2. Over Current Protection (OCP): Installed in all outputs. Overload Protection (OLP): Fully protected against output oveload and short circuit. Typically set at 130-150% max. load. Consult factory for special OLP setting.
GENERAL SPECIFICATION
Efficiency: Typ. 75-78%. Switching Frequency: 100 KHz. Circuit Topology: Half-bridge circuit. Transient Response: Typ. 1.0mS for a 25% load change. Safety Standard: IEC950/ UL1950 Class I. Construction: Eurocard 3U x 8HP x 160mm CompactPCI format. Front Panel with either Ordinary handle or Extractor handle. Operating Temperature: 0 to +50C at full load with specified air flow. Derates linearly to 50% at +70C. Storage Temperature: -40C to +85C. Temperature Coefficient: Typ. 0.02% /C. Cooling: At least 20cfm (600lfm) airflow is required to deliver full rating load. Power Density: 3.2 Watts /Cubic Inch.
Note: All measurements are at nominal input, full load, and +25 unless otherwise specified.
In application
TOTAL POWER, INT. Tel: 877-646-0900 Fax: 978-453-7395 Email: sales@total-power.com http://www.total-power.com -1-
OUTPUT VOLTAGE / CURRENT RATINGS CHART
QUAD OUTPUT
MAIN +VO1 @ Min. Typ. Volt. TPAC175P-490(E) 2.0A 20A +5V TPAC175P-490(O) 2.0A 20A +5V TPAC175D-490(O) 2.0A 20A +5V MODEL NO.
#=
Max. 35A 35A 35A
AUX. +VO2 #=@ AUX. +VO3= (@) Typ. Max. Typ. Volt. Max. Peak Volt. 10A +3.3V 20A 3.0A +12V # 5.0A 6A 10A +3.3V 20A 3.0A +12V # 5.0A 6A 10A +3.3V 20A 3.0A +12V 5.0A 6A
AUX. +VO4 = Typ. Volt. Max. Peak 0.5A -12V 1.0A 1.0A 0.5A -12V 1.0A 1.0A 0.5A -12V 1.0A 1.0A
Symbol: " " OVP built-in. "@" Adjustable. "(@)" Adjustable factory set. "#" Remote sensing. "=" Droop Load Sharing. "" Installed with Or-ing diode. "" Magnetic Amplifier. "" Installed with Post Regulator. Remark: Peak load less than 60sec. with duty cycle <10%. Max. load is the continuous operating load of each rail. But the max. load of each rail can't be drawn from all outputs at the same time.
MECHANICAL DIMENSIONS: MM [INCHES]
WEIGHT: 666.0g (23.5 Oz.)
INPUT & OUTPUT CONNECTORS PIN ASSIGNMENT
ASSIGNMENT AC-L AC-N AC-GND VO1 VO1 S + VO1 S VO2 VO2 S+ VO3 VO3 S+ VO4 DC COM EN# DEG # INH # FAL # PIN NO. 47 46 45 1,2,3,4. 30 34 13, 14, 15, 16, 17, 18. 33 20 36 21 5, 6, 7, 8, 9, 10, 11, 12, 19 ,24. 27 38 39 42
TPAC175P-490(E)
Mating connector: PCIH47F400A1
TPAC175P-490(O)
TPAC175P
INPUT & OUTPUT CONNECTORS PIN ASSIGNMENT
ASSIGNMENT AC-L AC-N AC-GND VO1 VO1 S + VO1 S VO2 VO2 S+ VO3 VO4 DC COM EN# DEG # INH # FAL # PIN NO. B2 B5 B11 B22 A17 A16 B13,14,15,16, 17,18. A18 B19 B20 B25 C13 C14 A14 C15
TPAC175D-490(O)
TPAC175D
TOTAL POWER, INT. Tel: 877-646-0900 Fax: 978-453-7395 Email: sales@total-power.com http://www.total-power.com -2-
Mating connector: DIN 41612 M24/8-F

▲Up To Search▲

Price & Availability of TPAC175P-490O

	To Download TPAC175P-490O Datasheet File
If you can't view the Datasheet, Please click here to try to view without PDF Reader .